To fully enjoy your engine and avoid any issues, you must follow the different assembly instructions before, during and after installing your engine. For each step, you will find below the different assembly instructions to follow:

For gasoline engines, it is necessary to remove the spark plugs to evacuate the oil contained in the cylinders (our engines are stored with oil in the cylinders to avoid seizure).

The following elements must be replaced with new products: * Calorstat * Trigger probe, indicative probes * Air filter, fuel filter, oil filters * Alternator belt, water pump belt * Engine oil, fuel * Antifreeze, coolant and lubricant of quality and viscosity equal to those specified by the manufacturer's standards * Spark plugs (ignition or preheat), platinum screws * Timing belt * Alternator belts * Distribution kit (belt and pulleys) * Water pump You must provide the engine tensioners, chains and belts yourself before installing the engine in the car. This applies to all engines, without exception. Please check carefully and replace if necessary: * Engine radiator and heating water hoses * Engine cooling radiator * Heating radiator * Coolant jar cap * Cooling fan * Turbo compressor * Clutch: mechanisms, disc, stop * Engine and gearbox engine mounts. Failure to replace the parts mentioned above is subject to your entire responsibility. Before starting the engine for the first time, you must ensure that the engine is properly filled with oil. The oil pump must also be filled. Most engines have an additional hole in the block to fill the oil manually. Use an oil pressure measuring tool to check that the engine will not start without oil.

Immediately and then after each use during the first 1000 km, and then according to the recommendations of the vehicle's maintenance book, check: * The proper functioning of the thermostat and the fan triggering, * The proper functioning of the water and oil warning lights, * The absence of water or oil leaks, * The level of water and oil (any abnormal consumption must be examined immediately) * The tension of the belts. When the engine is rebuilt, you must change the engine oil and oil filter, the turbo compressor separator filter after 1000 km of gentle driving. You must avoid aggressive acceleration. The engine must be maintained and used according to the recommendations of your vehicle's maintenance book.

Frequently Asked Questions

SPECIALIST IN USED ENGINES.

Didn't find what you were looking for?